If the optional front paper guide is installed, open the front cover and remove it. If the optional front sheet guide is installed, remove it by grasping the fins on both sides and pulling the guide slightly up and away from the printer. If necessary, install the paper guide on your printer as described in "Assembling the Printer" in the Setup Sheet. The tractor is installed in the rear push position when the printer is shipped. If the tractor is in the pull position, remove it following the instructions in Removing the tractor from the pull position. If the tractor is in the rear push position, remove the paper guide and then press the tractor's lock tabs while lifting it out. Installing the tractor in the front push positionīefore installing the tractor in the front push position, remove it from its current position. This section provides instructions on Installing the tractor in the front push position, Loading paper with the front push tractor, and Removing the tractor from the front push position. Using the tractor in the front push position This section provides instructions on Using the tractor in the front push position, Using the tractor in the rear push position, Using the tractor in the pull position, and Using two tractors in a push/pull combination. Follow the instructions below for your tractor position. The paper loading procedure depends on where you position the tractor which feeds paper to the printer. Loading continuous paper with the tractorįollow the instructions in this section to load continuous paper in the printer.īefore using continuous paper, make sure you line up your paper supply with the tractor feeder as shown below, so that the paper feeds smoothly into the printer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |